the workpiece must be timely added abrasive grinding conditions

The operator must be familiar with the general structure and properties of the device shall not exceed the performance using the device. Parts and abrasive hopper volume must not exceed 90% of ceramic flap disc  the volume. After power for air operation, should be smooth, no abnormal noise. Otherwise, should stop to check. Workpiece before grinding, the workpiece must be decontaminated off the oil. During processing of the workpiece must be timely added abrasive grinding conditions and control the amount of water added. After work shutdown, power off, cleaning equipment, good equipment maintenance work. Safety procedures before starting, check the fastening screws, check the motor shaft rotation is flexible. Equipment in operation, abnormal should immediately stop. Every six months, should the vibration motor or rotary shaft bearing oiling mouth filling lithium grease. Work, should be cut off the power.
Empty load test run. Turn right and analysis of the host machine. Host empty load test run by steering requirements, the nonwoven belt  running time of not less than 1h. Host empty load operation, should roller device with rope fastened to avoid contact with the grinding roller and grinding ring combat, such as unconditional, but also the roller device removal. Host empty load test run should be smooth, lubricating maximum temperature not exceeding 800c. Temperature must not exceed 400c. Analytical Engine Size bevel gear operation should be smooth, no unusual sounds, and to ensure smooth flow of oil. Direction of rotation of the blower should be observed, there should be no abnormal sound and vibration, bearing maximum temperature not exceeding 700c, temperature does not exceed 350c. Meet commissioning. By air load test run proved that each component can work only when carried out in line  Mounted flap wheel commissioning. Commissioning meet not less than 8h (hours). Mill work should be normal, not normal transmission parts may not have sound and shock and vibration. Rolling and oil temperature does not exceed 800c, temperature does not exceed 400c. Conduit means there should be no leakage of the flange contact phenomena. Milling yield within specifications. Adjustment of speed, so that the finished granular control in the range of 0.44-0.125mm. By air load and the load so the operation after passing again fasteners, can be put into normal operation